Download FREE Practo app
Get ₹200 HealthCash
3D printer encounter with a finger nail.
I was pulling my 3D printed object off of the plate, and I had to use my finger nail to scrape off this small strand, and without thinking, I approached it from the end of it, and when scraping it off, it slipped and jabbed between my nail and finger. I tried to take a picture but it’s hard to see through the nail, and if it’s of any consequence the strand was about .3-.5 mm in diameter. You can still see where it went in through my nail, and separated it from the nail bed. Need treatment?
Answers (1)
Like the answers? Consult privately with the doctor of your choice
Need to see before starting treatment.... Do direct online consultation by sending photos, otherwise meet me at my clinic, for accurate diagnosis and treatment
Answered
Flag this answer
Let others know if this answer was helpful
Was this answer helpful?
YES
NO
Articles you may like
Disclaimer : The content is not intended to be a substitute for professional medical advice, diagnosis, or treatment. Always seek the advice of your physician or other qualified health provider with any questions you may have regarding your medical condition. Never disregard professional medical advice or delay in seeking it because of something you have read on this website.
The question asked on this page is a free question. You can ask a free health question by downloading the Practo app.
Articles you may like
Tell us what's troubling you
Tell us what's troubling you
Disclaimer : The content is not intended to be a substitute for professional medical advice, diagnosis, or treatment. Always seek the advice of your physician or other qualified health provider with any questions you may have regarding your medical condition. Never disregard professional medical advice or delay in seeking it because of something you have read on this website.